For most projects, only 1 color stain is used when working with woodnonetheless, using two or more colors of stain can include intricate detail to an otherwise ordinary piece. Although the end results are typically stunning, getting to that point takes a good amount of planning and work.
Prepare the Wood as far as Possible First
Begin by sanding down the whole bit to smooth it out and then remove any topcoat, constantly sanding with the grain of this timber, then wipe it down with a damp cloth to remove dust. Follow with a wood conditioner applied to the whole surface. This will aid the wood absorb the stain evenly, providing you the very best outcomes. Additionally, it, per its name, conditions the timber, which makes it soft and supple and thus preventing cracking or splintering in the future. In the event you have to remove existing blot, do this with timber bleach, that comes at a two-part solution at most hardware stores. Mix the 2 products based on manufacturer instructions, apply it evenly to the timber, then wash it off once the old stain fades. Apply vinegar to the full piece to stop the bleaching process, then let this dry before sanding and conditioning the timber. To finish the preparation stage, draw a comprehensive guideline on the timber with a pencil dependent on the layout you need to create with the two stains. When you are done, step back from the item and check that it is even and exactly as you would like it to be.
The First Color
After painting, you can often apply a base coat to the whole area, tape off any layout and then apply another color on top of the first. By comparison, each wood stain color is best applied to bare timber. For this reason, you’ll have to completely tape off one area that will get the second color before implementing the first. If you are only doing straight lines, standard painter’s tape will work. If you are doing any scrolls or other curves, however, masking tape will function best. It is easier to tear into small pieces, which means fitting it around even the tightest curve is relatively simple. Painter’s tape is often too thick to do this readily. Take your time on this step for the crispest outcome, then apply the first blot color per the manufacturer’s instructions. Let it dry completely before continuing.
The Second Color
Once the first color is dry, you can remove all of the tape and then move to tape off the areas you stained. Provided that the stain is truly dry, it won’t damage your work. It is possible to use exactly the same process as before, if with painter’s tape or masking tape, then apply your second blot color in line with the manufacturer’s instructions. For the best results, use exactly the identical type of dye as the first color, just at a different colour, and wait for it to dry completely before removing the tape.
Consistently Employ a Topcoat
To keep your hard work secure, a clear topcoat is essential. Provided that you wait for the blot to be completely dry, you can apply the topcoat to the whole surface. Use the identical base topcoat as you did blot (water with oil or water with oil) to find the best outcomes.