Travertine tile is a calcium-centered stone that has been formed inside warm springs. Water vapor escaping the stone as it cooled and hardened shaped pits and channels in the stone which are still obvious in the tile. These holes aid to give its look to travertine and complete. The holes left un-filled to offer a more organic look, or may be filled through the grouting procedure to help stabilize the stone, help keep it clear and give it a finished appearance.
Filling the Travertine Holes
By brushing the best area using a foam paint brush seal the the top of travertine dampened with stone sealer. Avoid acquiring extra sealer from sticking there, as this can prevent the grout. The sealer will be to help make the grout cleanup in the surface of the tile more easy. Let the sealer sit for 10 minutes, then buff it away using a fabric that is soft.
Till it’s the consistency of peanut-butter mix up the sanded grout. Scoop up an orange- ball of grout and use it to the the top of travertine with all the float.
Drag the grout float the whole tile on to drive the grout equally involving the tiles and in the holes. Hold the float at a 45-degree angle to the tiles and drive it flat onto the joints as well as bigger holes to aid pack. Make passes from several guidelines to help ensure the grout enters joints and each of the holes.
Turn the float nearer to to 90-degrees and start scraping off the excess grout. This may help drive the grout in to the holes.
Wait 10 minutes for the grout to start to harden. Dampen a sponge that is grout and begin to wipe-clean the the top of tiles. Use the edges of the sponge to form the grout around joints and the bigger holes. Don’t over-wet the sponge, as this may wash the grout again from joints and the holes. Continue wiping the the top of tiles until all extra grout is removed. Allow the travertine to dry for 2-4 hrs.
Leaving the Holes Un-Filled
Apply a coat of sealer to the whole area of the tiles. Make sure that the sealer enters the holes of the stone. This can help stop the grout. Let the sealer penetrate for 1 minutes, then buff it away using a fabric that is soft.
Mix up the sanded grout till it reaches the consistency of peanutbutter that is delicate. Scoop up a really little a-Mount on the finish of the grout float.
Use the grout in the corner where four tiles satisfy. Use the best fringe of of the float held a-T a 4 5-degree angle to the tiles to drag the grout over the joints of the tiles. Make tiny passes from sidetoside a joint to aid pack the grout on. Try maybe not to get also much grout on the the top of tile it self.
Let the grout dry for 1-0 minutes, then clean a-way the excessive having a damp sponge. Rinse the sponge often to aid eliminate the grout that is additional. Shape the lines using the edges of the sponge. Use the corners of the sponge to clear it a-way if any grout entered the bigger holes of the tile. Let the tiles dry for 2-4 hours.
